![]() ![]() I loaded the Telephone module and read it. There is some help info in Navcoder that I will leave to you to read before messing with your car. So then I got the Navcoder software reading the iBUS (you need to turn the ignition key to position 1) and could see information on the various modules. You will need the USB drivers for the Resler that are on Rolf Resler's site. Just to clarify, there are 4 x wires from the Resler interface - I didn't need the Green, NTSC wire and I just matched the colours: white to white, red to red (the middle wire in the plug for power) and brown to brown. The plug I purchased from the Dealer did not have any pins inside that would insert into the loom connector and so it didn't work But never mind I simply removed the new plug and stripped the ends of the wires and pushed them in manually into the loom connector (not elegant but it worked) then kept them in place with tape. I might have been missing something but the plug that comes from my cars wiring loom and connects to the CD Changer requires the female plug to have pins that stick out inside an thus insert into the loom plug when connecting. I bought the parts as kindly suggested by RichardP - the plug was the correct fitting and I was able to solder the Resler wires to the bushing contacts. ![]() Hi all, thought I would provide an update of my experiences with the Resler interface and Navcoder. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |